Last edited by Meztibei
Sunday, May 17, 2020 | History

2 edition of On the spectral emissivity of polydispersions, application to coal found in the catalog.

On the spectral emissivity of polydispersions, application to coal

Sergio Lara Pereira Monteiro

On the spectral emissivity of polydispersions, application to coal

by Sergio Lara Pereira Monteiro

  • 267 Want to read
  • 6 Currently reading

Published .
Written in English

    Subjects:
  • Coal -- Spectra.

  • Edition Notes

    Statementby Sergio Lara Pereira Monteiro.
    The Physical Object
    Paginationxii, 133 leaves :
    Number of Pages133
    ID Numbers
    Open LibraryOL16522229M

      Spectral (in the wavelength range of 1 – 25 μm) and total emissivity of reaction bonded silicon nitride were determined together with their temperature dependence in the range between room temperature and K. The influence of ytterbium oxide and nickel impurities on the optical properties of the material was investigated. Emissivity was determined from the total reflectance spectra at Author: R. A. Mironov, A. V. Lanin, M. O. Zabezhailov, A. E. Kryukov, A. I. Ganichev, M. Yu. Rusin. Computational results for the spectral emissivity ε λ at T = K are presented in Fig. 1. Calculations were made by use of the DP 1 analytical solution (see the article, “The simplest approximation of double spherical harmonics”). Similar dependences for the values of T = K and K can be found in the book by Dombrovsky ().

      The apparent normal spectral emissivity and transmissivity of this sample are measured first (see Fig. 9). From the plots, we find that the apparent normal spectral emissivity and transmissivity of this sapphire sample vary little with wavelengths in a range of 3 μm–4 μm, emissivity is around , and transmissivity is around Cited by: 5. • Spectral Intensity, I λ,e+r – a quantity used to specify emitted and reflected radiation intensity • The integration of the spectral heat flux is called the spectral radiosity – spectral emission+reflection (heat flux) over all possible directions • The total heat flux from the surface due to irradiation over all.

    Two methods are developed for measuring low-temperature spectral emissivities in the infrared region. Neither of these has apparently been employed previously. One of them, which is only an approximate method, was followed by measurements of three common alloys. The values of emissivity obtained agree reasonably well with those calculated from the reflectivity data of others for similar materials. (). The impact of spectral emissivity on the measurement of land surface temperature from a satellite. International Journal of Remote Sensing: Vol. 8, No. 10, pp. Cited by:


Share this book
You might also like
First principles of typography.

First principles of typography.

Ducks of Sub-Saharan Africa

Ducks of Sub-Saharan Africa

Water quality monitoring strategy for the Forest Practices Code of British Columbia, June, 1995.

Water quality monitoring strategy for the Forest Practices Code of British Columbia, June, 1995.

Native Peoples

Native Peoples

Pay of Warrant and Commissioned Warrant Officers, U.S. Navy.

Pay of Warrant and Commissioned Warrant Officers, U.S. Navy.

Skills practice manual for Health unit coordinating

Skills practice manual for Health unit coordinating

Ill Be Seeing U

Ill Be Seeing U

Hours, records and tachographs.

Hours, records and tachographs.

Improving the opportunities and achievements of the children of the poor

Improving the opportunities and achievements of the children of the poor

General Physics

General Physics

Visible mending

Visible mending

Development of libraries

Development of libraries

Universal design handbook

Universal design handbook

Labor problems

Labor problems

Development policy and analysis

Development policy and analysis

On the spectral emissivity of polydispersions, application to coal by Sergio Lara Pereira Monteiro Download PDF EPUB FB2

Photo-absorption and scattering properties of coal particle polydispersions are measured in the wavelength region from 1 to 5 (mu)m. The facility constructed for this task is described and a detailed analysis of the experimental and analytical procedure employed to obtain emissivity data is presented.

Precise knowledge of the emissivity (epsilon) is important for the. calculation of radiative Author: Sergio Lara Pereira Monteiro.

thedatain[3] show that total emissivity for coal ash and sediment samples between 1 and 15 µ m at high temperatures (> K) resembles the spectral value near 4 µ m. Effects of temperature on the spectral emissivity of C/SiC composites Ceramics – Silikáty 60 (2) () L bb (λ, T) are the radiation of specimen and blackbody, respectively, and L n (T e) is the environmental radiation.

Combining Equations 1 and 2, one obtains. (3) When the output signal of File Size: application to coal book. Infrared spectral emissivity studies on metals and materials application to coal book solar thermal applications Figure Copper normal spectral experimental emissivity: (a) from Figure Normal spectral emissivity at seven different temperatures for AISI.

Furthermore, the image captured by the hyper-spectral imaging device records the spectral and spatial history of the single burning coal particles throughout the combustion process. Then, the time–space temperature and apparent spectral emissivity of the single burning char particles are calculated from the time–space spectra radiative Cited by: 2.

The spectral emissivity function of an opaque surface at K is approximated as. Determine the average emissivity of the surface and the rate of radiation emission from the surface, in W/m Answer:kW/m 2.

The combined GMM and DLA model predicts spectral emissivity better than the original Mie theory and Tien's dependent scattering theory with the average relative difference between predicted results and experimental data decreasing from % to % for sample 1 and from % to % for sample by: 6.

gives the upper limit of the ash deposit spectral emissivity. [DOI: /] Keywords: ash deposit, spectral emissivity, microstructure, chemical composition. Post-mining sites have a significant impact on surrounding ecosystems.

Afforestation can restore these ecosystems, but its success and speed depends on the properties of the excavated spoil substrates. Thermal infrared remote sensing brings advantages to the mapping and classification of spoil substrates, resulting in the determination of its by: 1.

This document reports the findings of a market and research review related to state-of-the-art highly insulating window frames. The market review focuses on window frames that satisfy the Passivhaus requirements (window U-value less or equal to W/m{sup 2}K), while other examples are also given in order to show the variety of materials and solutions that may be used for constructing window.

The effects of materials’ surface oxidation and roughness on spectral emissivity have been investigated for design improvement and effective thermal management of energy systems.

Experiments confirm that both surface oxidation and surface roughness affect spectral emissivity with surface oxidation having a more dominant by: @article{osti_, title = {HIGH TEMPERATURE SPECTRAL EMISSIVITY STUDIES}, author = {Riethof, T R}, abstractNote = {Presented at the conference on Radiative Transfer from Solid Materials, Boston, Mass., DecemberThe techniques used to measure normal spectral emissivities of opaque solids at high temperatures and their relative merits in light of experimental difficulties are.

emissivity, these properties can also be defined for a specific wavelength and/or direction. For example, the spectral directional absorptivityand spectral directional reflectivityof a surface are defined, respectively, as the absorbed and reflected fractions of the intensity of radiation incident at a spec-ified wavelength in a specified File Size: 96KB.

A methodology to create a high spectral resolution emissivity database from the moderate spectral resolution UW/CIMSS BF emissivity dataset was described.

A Software Tool to extract the high spectral resolution emissivity database from the UW/CIMSS BF emissivity dataset will be available in early A beta version is available for testing. The spectral, hemispherical absorptivity of an opaque surface and the spectral distribution of radiation incident on the surface are shown below.

(um) (um) a. What is the total hemispherical absorptivity of the surface. If it is assumed that aw and that the surface is at K, what is the total hemispherical emissivity.

Spectral Emissivity, Total Emissivity, and Thermal Conductivity of Molybdenum, Tantalum, and Tungsten above °K Journal of Applied Phys ( The spectral emissivity shows negligible variation over the width of this band at a given temperature.

Google Scholar; by:   This study is a high spatial resolution analysis of plant species’ emissivity and LST using HyTES imagery acquired in the Huntington Botanical Gardens on July 5 and Jan Leaf and canopy emissivity variation was identified among 24 plant species and used to determine leaf to canopy scaling capabilities.

A number of various high emissivity coatings has been investigated in detail. Oxide ceramic coatings for rotating x-ray anodes must have a total emissivity greater than in order to ensure efficient cooling in vacuum. Only one of the investigated coatings showed sufficient long-term stability.

For thermal protection of reusable space transportation systems during atmospheric reentry, in Cited by: Determination and Analysis of the Spectral Emissivity of a Blackbody Simulator Source Dustin Holt Crider University of Tennessee - Knoxville This Thesis is brought to you for free and open access by the Graduate School at Trace: Tennessee Research and Creative Exchange.

It has been. The spectral and total emissivity of particulate ash deposits of different chemical composition which originate from lignite and hard coal fired boilers from Alstom Power and RWE Power were investigated with a spectral radiometer.

Furthermore the emittance of all major single phases present in ashes and slag have been by: 7. The emissivity of silicon was observed in the spectral region from to 15 µ at various temperatures from °K to °K by using two n-type specimens with the resistivity of 15 ohm-cm and 7× ohm-cm at °K, respectively.

The thermal radiation of silicon consists of three types due to band-to-band transition, free carriers and lattice by: -R-OSR-~T-7 8-L PROPERTIES RESEARCH LABORATORY SPECTRAL AND TOTAL EMISSIVITY AND REFLECTIVITY AT HIGH TEMPERATURES (1 Feb )1Dan Ap B V D. P. DeWitt, T. K. Riddle and R.

E. Taylor ~ I approved for public release; distribution unlimited School .spectral decomposition to image stratigraphic features and confirmed the results obtained from AVO analysis and inversion of seismic data from Blackfoot field, Alberta, Canada. Recently magmatic intrusions into a coal bed were detected by using spectral decomposition (Wang et.

al., ). Liu and Fomel () used spectralFile Size: KB.